Thread: Which Connection ?
-
01-10-2013 #11
Hi Jazz
Many thanks, it's not to late to move the Bob, i will do your recommendation when i have finished the Mill.
Regards
Ray
-
01-10-2013 #12
Hi Jazz
If i read you right you are suggesting i shorten the cables that are already attached to the motors, then run 4 core shielded cable back to the drivers, but will this not leave a small amount of cable unshielded ?
Ray
-
01-10-2013 #13
Hi Jazz
My Motors are SY57STH76-3008E & SY60STH86- 3000BF
Regards
Ray
-
01-10-2013 #14
Yes you read correct but think you must have missed this bit.? . . ."One thing I've done in past is have a small connection box near Stepper so unshielded wires to motor are short, I wrap these with foil and shrink wrap then use Gremflex shield on outer. "
Ok well I couldn't find SY57STH76-3008E data sheet only 3008B so if your wire colours differ then let me know or send me a link to data sheet.
So First SY57STH76-3008B (E)
Phase 1
A + = RED + BLUE
A - = Yellow + BLACK
Phase 2
B + = White + BROWN
B - = Orange + Green
SY60STH86- 3000BF
Phase 1
A + = Blue/White + RED
A - = Red/White + Blue
Phase 2
B + = Green/white + Black
B - = Black/white + Green
Hope this helps.!
-
The Following User Says Thank You to JAZZCNC For This Useful Post:
-
02-10-2013 #15
-
02-10-2013 #16
Yes but wouldn't be my first choice to fasten box on stepper directly but if your only option then fine. Have you seen these type motor end covers with connections Nema 24 (60mm) stepper motor end cover | eBay
Not saying buy these has they are expensive but if you talk nice to someone Say Clive S . . . . they might be up to 3D print you some and they are very neat.
Also don't take the shield back to the Drive Ground take it back to the Main star ground point.
-
The Following User Says Thank You to JAZZCNC For This Useful Post:
-
02-10-2013 #17
Thanks Jazz
Those covers on E Bay look great, but they will prevent me using the manual wheels, my steppers have the spindle at both ends, i thought it would be useful if i was only doing a quick milling job, instead of setting up on mach 3.
Ray
-
13-07-2020 #18
Looks good
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Connection the plasma cutter to the CNC machine?
By gr8fun in forum Plasma Table MachinesReplies: 1Last Post: 22-05-2014, 10:49 AM -
Or Guidance ;) Connection Name(s)
By Carlb1058 in forum Marketplace DiscussionReplies: 6Last Post: 13-07-2013, 12:48 AM -
Wire Connection Diagrams
By Lee Roberts in forum Stepper & Servo MotorsReplies: 14Last Post: 03-01-2013, 06:56 PM -
ghost in the x axis - bad electrical connection
By jonm in forum General ElectronicsReplies: 5Last Post: 11-04-2010, 08:31 PM -
plan request connection card PCPPS
By ali hedi in forum General ElectronicsReplies: 2Last Post: 07-04-2010, 08:18 PM
Bookmarks