Thread: Which Connection ?
Threaded View
-
30-09-2013 #1
Hi all.
I am nearly ready to wire up my Stepper Motors to there relevant Drivers. But the more i look into it, the more i become confused?
I have 2, NEMA 23's (SY57) & 1, NEMA 23 (SY60) all 3 have 8 wires coming out of the body through a built in Grommet.
I have read were it is best to wire the cables directly on to the Driver, I have read were you can use XLR plugs & sockets, i have read i need to screen the wires, i have read there is no need to screen the wires, i will be wiring in Bi Polar, therefore 4 of the wires will not be used, do i cut these off near to the body, how do i screen the wires, and which ones ? if i use screened cable do i have to go into the stepper and remove the original wiring at source?
Can anyone help please, and remove this confusion.
Regards
Ray
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Connection the plasma cutter to the CNC machine?
By gr8fun in forum Plasma Table MachinesReplies: 1Last Post: 22-05-2014, 10:49 AM -
Or Guidance ;) Connection Name(s)
By Carlb1058 in forum Marketplace DiscussionReplies: 6Last Post: 13-07-2013, 12:48 AM -
Wire Connection Diagrams
By Lee Roberts in forum Stepper & Servo MotorsReplies: 14Last Post: 03-01-2013, 06:56 PM -
ghost in the x axis - bad electrical connection
By jonm in forum General ElectronicsReplies: 5Last Post: 11-04-2010, 08:31 PM -
plan request connection card PCPPS
By ali hedi in forum General ElectronicsReplies: 2Last Post: 07-04-2010, 08:18 PM
Bookmarks