Which Connection ?

[JAZZCNC]

Hi Jazz

Many thanks, the wires on my Stepper motors are long enough to reach the drivers in my cabinet, how do i sheild them if i do that?

Personally I'd use some shielded cable and shorten wires on motors and run this back to cabinet.
One thing I've done in past is have a small connection box near Stepper so unshielded wires to motor are short, I wrap these with foil and shrink wrap then use Gremflex shield on outer. Then run shielded wire from connection box back to control box.

Failing that then you could just wrap with aluminium foil to act has rough shield and then shrink wrap then cover with this Gremflex like seen here. CNC wiring Accessories Wouldn't be my first choice thou.!!