Thread: Which Connection ?
Threaded View
-
01-10-2013 #11
Last Activity: 24-11-2014
Hi Jazz
If i read you right you are suggesting i shorten the cables that are already attached to the motors, then run 4 core shielded cable back to the drivers, but will this not leave a small amount of cable unshielded ?
Ray
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Connection the plasma cutter to the CNC machine?
By gr8fun in forum Plasma Table MachinesReplies: 1Last Post: 22-05-2014, 10:49 AM -
Or Guidance ;) Connection Name(s)
By Carlb1058 in forum Marketplace DiscussionReplies: 6Last Post: 13-07-2013, 12:48 AM -
Wire Connection Diagrams
By Lee Roberts in forum Stepper & Servo MotorsReplies: 14Last Post: 03-01-2013, 06:56 PM -
ghost in the x axis - bad electrical connection
By jonm in forum General ElectronicsReplies: 5Last Post: 11-04-2010, 08:31 PM -
plan request connection card PCPPS
By ali hedi in forum General ElectronicsReplies: 2Last Post: 07-04-2010, 08:18 PM
Bookmarks