. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 01-10-2013 #13
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    Quote Originally Posted by manofgresley View Post
    Hi Jazz

    If i read you right you are suggesting i shorten the cables that are already attached to the motors, then run 4 core shielded cable back to the drivers, but will this not leave a small amount of cable unshielded ?
    Yes you read correct but think you must have missed this bit.? . . ."One thing I've done in past is have a small connection box near Stepper so unshielded wires to motor are short, I wrap these with foil and shrink wrap then use Gremflex shield on outer. "

    Quote Originally Posted by manofgresley View Post
    My Motors are SY57STH76-3008E & SY60STH86- 3000BF
    Ok well I couldn't find SY57STH76-3008E data sheet only 3008B so if your wire colours differ then let me know or send me a link to data sheet.

    So First SY57STH76-3008B (E)

    Phase 1
    A + = RED + BLUE
    A - = Yellow + BLACK

    Phase 2
    B + = White + BROWN
    B - = Orange + Green

    SY60STH86- 3000BF

    Phase 1
    A + = Blue/White + RED
    A - = Red/White + Blue

    Phase 2
    B + = Green/white + Black
    B - = Black/white + Green

    Hope this helps.!
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to JAZZCNC For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Connection the plasma cutter to the CNC machine?
    By gr8fun in forum Plasma Table Machines
    Replies: 1
    Last Post: 22-05-2014, 10:49 AM
  2. Or Guidance ;) Connection Name(s)
    By Carlb1058 in forum Marketplace Discussion
    Replies: 6
    Last Post: 13-07-2013, 12:48 AM
  3. Wire Connection Diagrams
    By Lee Roberts in forum Stepper & Servo Motors
    Replies: 14
    Last Post: 03-01-2013, 06:56 PM
  4. ghost in the x axis - bad electrical connection
    By jonm in forum General Electronics
    Replies: 5
    Last Post: 11-04-2010, 08:31 PM
  5. plan request connection card PCPPS
    By ali hedi in forum General Electronics
    Replies: 2
    Last Post: 07-04-2010, 08:18 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules