Romi EZ-Path S Lathe crt replacement

[asbo]

Maybe this will help
I imagine the best thing to do is have poke around inside it, according to that there might be a plain simple VGA connector

[Nemo1966]

Maybe this will help
I imagine the best thing to do is have poke around inside it, according to that there might be a plain simple VGA connector

Thanks for the info - however my problem is that the crt does not use a standard vga connector. The connector is labeled P101B. I am asumming that it runs on a 386 motherboard so I am going into the back and see if i can find a vga plug on that. I was hoping that I would be able to rewire the p101b connector to a vga d-sub connector.

thanks again
Steve

[EddyCurrent]

Second link has some instructions

BRIDGEPORT EZ-PATH LATHE EZ-TRAK MILL LCD MONITOR KIT | eBay
COLOR Monitor For Bridgeport EZ Path lathe - Replace that small monitor! | eBay


EZ-Path Lathe

[Nemo1966]

Second link has some instructions

BRIDGEPORT EZ-PATH LATHE EZ-TRAK MILL LCD MONITOR KIT | eBay
COLOR Monitor For Bridgeport EZ Path lathe - Replace that small monitor! | eBay


EZ-Path Lathe

Thanks for the info - but I wish it was that easy. The lathe we have does not have the connections that the ones you have listed have. The lathe we have has no connectors on the display box at all. Inside on the crt the vga cable if plugged directly into the crt board (not with a standard vga connector). I have the tech spec diagrams but these do not corrolate with the actual plug P101B.

[Nemo1966]

Ok got in the back and found the VGA connector. - all sorted thanks