Stell frame cnc 1500X1000. Adjustable table your opinion please

[ba99297]

Some small changes





The green plate(20mm aluminium plate ) will be bolted on the carriages and then i will bolt the green plate with the red plate (20mm aluminium plate)
Could anybody told me what are the critical spots that i must have freedom to adjust. I think is obvious that the spindle should be vertical with the cutting surface. Is this possible to achieved by putting shims between the red and the green aluminium plate.

[JAZZCNC]

Vagelis can you show an exploded view or See thru view so that can see how Steel fastens etc. This seems a very complex arrangment of plates that may not be required or adding a lot to overall strength.? The design is correct regards gantry sides Etc just looks more complicated than it needs to be.

I'm also curious to how your arranging the ballscrew/motors because it looks like the steel supports across gantry could clash with ballnut.?

If you prefer Email me Model.