Quote Originally Posted by ba99297 View Post
Two questions

#1 If you see the the top right photo you will see that i dont make a full welding pass just 3 spot ( edges and at the middle ) in order not to produce too much heat. Is that ok or should i weld all the way?

# 2 Do you think that more diagonal support will be needed and where?


Thank for your time

Vagelis
Hi Vagelis,

#1 I believe what is below the gantry and the gantry itself should be fully welded. Anyways later you will epoxy it for leveling. I spot welded only the Z which seemed strong enough/on my build i mean/

# 2 To me it seems there would be no need, especially with your monstrous table bed