Thread: Validation of power supply
Hybrid View
-
08-09-2007 #1
Spent a bit of time investagating this.
System powered up and x,y & z steppers locked .................25.8v 1 amp
X fast traverse, Y & Z locked........................................1.4a mp
as above plus heavy load added manually
( in use it will never be anywhere near this load)..................2.0 amp
Y as above............................................. .................Same
X+Y fast traverse Z locked............................................ 2 amp
z fast traverse x &y locked...........................................1 .1amp
Voltage pulls down <1volt
My motors are supposed to be 2.4amp each so I conclude that power supply is well big enough and motors are never loaded to their full rating.
Conclusion. Power supply 'seems' validated.
Any thoughts?
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
Power Supply Suggestions please..
By Ricardoco in forum General ElectronicsReplies: 37Last Post: 30-01-2013, 06:37 PM -
PCPPS V3 Power Supply?
By birchy in forum General ElectronicsReplies: 4Last Post: 10-12-2012, 04:21 PM -
Minimal-cost Power Supply Strategy - Repurpose Laptop Power Supplies
By LoveLearn in forum General ElectronicsReplies: 0Last Post: 25-01-2012, 09:29 PM -
FOR SALE: 50V 20A Power supply
By Jimmybristol in forum Items For SaleReplies: 8Last Post: 30-05-2011, 11:01 PM -
power supply
By hitmythumb in forum General ElectronicsReplies: 6Last Post: 21-06-2009, 10:27 AM
Bookmarks