Quote Originally Posted by Want2build1 View Post
??? should I be concerned at this ??? !!!
Dont know, you decide. Finished my drawing in Sketchup and ordered everything. As i have some laser cut pieces i decided not to order them until i have all here to measure.

While all the ballscrews were machined to 0.01 and fit perfectly in the supports, they send me ball nut housings which they had at hand, so had to redraw a whole day. That affected the Z width also and the Z distance from gantry, so had to redraw there too. Also the spindle bracket i bought is quite bigger than at the ebay listings picture and wider by 20mm, so i could have bought 1 only, not 2, and if my Z was ready it would not fit, because of the fixing holes situation.

I mean, make the bead structure, but careful after that until you have the main parts at hand.