. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Hi Phill

    If you can't sort it I can have a ride over and have a quick look at it with you.

    As for the charging I have no clue what they are on about other than they may be talking about the large capacitors on the board which if they are I have never heard of that before!

    Send me a pm if you want any help with your phone number and I will give you a call.

    Regards

    Andy

  2. #2
    Phill,
    I hadn't picked up from your posts that it would run for a while before faulting again, I read it as though it would not work at all. The capacitor issue is called 'forming' or in this case 'reforming' it's always been an issue for quality stereo system amplifiers too.
    Have a read at this post, I put a link in there about it.
    http://www.mycncuk.com/forums/router...pping-rcd.html

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Bearing fit problem
    By paulus.v in forum Linear & Rotary Motion
    Replies: 7
    Last Post: 09-10-2013, 09:54 AM
  2. Problem with X
    By gorbo in forum General Discussion
    Replies: 17
    Last Post: 24-02-2011, 05:33 AM
  3. z axis problem on rye ma 1500 with a bosch cc100
    By rickybabe in forum Rye CNC Routers
    Replies: 3
    Last Post: 28-04-2010, 09:04 AM
  4. Problem with calibration
    By m.marino in forum Gantry/Router Machines & Building
    Replies: 5
    Last Post: 22-04-2010, 04:19 PM
  5. Z Problem
    By airwolf in forum Machine Discussion
    Replies: 2
    Last Post: 10-11-2009, 08:08 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •