Help needed for a 3d part gcode for mach3

[JAZZCNC]

Fixture or Jig?
A bit like the difference between cannot and may not but both important distinctions IMHO;-)

Know what your meaning has Fixture is very different to Jig and actually often a fixture holds a Jig.!!. . . but Neither are needed actually.?

Because the slot tops are all on same plane there's a flat surface for when flipped, if the outer profile is done at same time has slots then It's a simple rectangle so when flipped new work coordinates are taken from the corner and material lower surface. No special indexing or jigs are required. . . . The Difficult bit will be work holding and even then that's not too difficult has it can be held in vice or clamped from the ends.

Thou like Irving says because of it's small size then chances are longer lengths will be machined then cut to length.? . . . . . .That's how I would do it anyway.