Help needed for a 3d part gcode for mach3

[JAZZCNC]

Without interrogating a drawing accurately I'd guess at 10mm rad but only cutting over about 6mm of material.
So guessing it could be formed onto a worn or old 8mm or 10mm cutter, possibly less.

My first thought was the same John about grinding a profile but to stay strictly to the drawing then 3 x Rad would be needed has can be seen from this end profile. . . If can't be changed then thats 3 tools to grind.!!


Base Could be done with 9 & 14mm ballnose with part on it's edge but thats then messing around with another clamping op and setup and not everyone has 4th axis.

Personally If I was doing them, Then For lower base I'd just shoot 9 & 14mm ballnose up each edge and flat mill up centre, obviously done horizontal.
For the other side it's obvious for slots but the round over then I would grind a tool I think. I'd also make them in longer lengths and cut to size.!!
This would be very quick and don't think it could be done quicker really.?