Thread: EMCO Spindle Control
-
06-11-2013 #1
Hello, sorry im being a bit of a pain during this CNC conversion. But I am learning a lot. Especially on the wiring side of things.
I hope this will be my final saga in the EMCO Conversion. I have the machines 2 axis moving fine now. All that remains is the Spindle control.
I bought the C6 board as advised on a previous thread. But I cant seem to figure out how to wire this in. I am using a HG07 break out board from CNC4YOU.
Could someone please advise me on how to set up the spindle control using these devices. I feel I could be missing a piece of the jigsaw.
Cheers,
Pete
-
06-11-2013 #2
Pete,
Does this thread explain it enough ?
http://www.mycncuk.com/forums/router...ter-mach3.html
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Emco C5 spindle motor control
By GeoffV in forum Motor Drivers & ControllersReplies: 2Last Post: 19-03-2014, 04:20 PM -
PCPPS B.O.B. - OK for spindle control?
By birchy in forum Spindles & Drive MotorsReplies: 4Last Post: 09-09-2013, 12:50 AM -
Spindle Speed Control
By cncJim in forum Spindles & Drive MotorsReplies: 15Last Post: 18-06-2013, 07:53 PM -
Help with spindle control
By wizzy in forum Spindles & Drive MotorsReplies: 4Last Post: 12-02-2011, 12:51 AM -
CNC spindle control VFD problem
By djc in forum Motor Drivers & ControllersReplies: 1Last Post: 13-09-2009, 09:26 PM
Bookmarks