Threaded View
-
14-11-2013 #1
I have 3 m542 steppers, 33v power supply and the following three steppers for my x,y,z axis; Vexta steppesr:
X= PK 296-02AA (2 Phase 1.8° step, DC, 3A)
Y: PK268-03A (2 Phase 1.8° step, DC, 3A)
Z: PK268-03A (2 Phase 1.8° step, DC, 3A)
and a 5 axis breakout board like this one
What setting on the DIP switches should I be setting
Also what setting should I be setting in Mach3 in the motor tuning section.
The travel of the x axis is 80mm per revolution of the x stepper motor if this is required for setting calculations.
Thanks in advance for any help or advice. More info on my DIY build/retrofitting can be found here http://www.mycncuk.com/forums/diy-cn...html#post51435
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Random G-code for testing motor tuning.
By Jonathan in forum Stepper & Servo MotorsReplies: 2Last Post: 30-10-2019, 08:22 AM -
Pulse rate or dip switch settings
By Jopo in forum Stepper & Servo MotorsReplies: 0Last Post: 29-04-2013, 08:08 AM -
Switch for motor?
By newtoid1986 in forum Electronic Project BuildingReplies: 4Last Post: 27-06-2012, 03:37 PM -
Help please with motor tuning mach 3.
By Kevin1970 in forum Artsoft Mach (3 & 4)Replies: 6Last Post: 13-06-2012, 10:22 PM
Bookmarks