Stopped playing with it, bolted it to the mill and it has a problem, I'll probably have to give the man a ring on Monday unless someone knows...

Autotune gives me "ATER Autotune error"

The manual says (sic)...

Auto-tuning faults
1. Motor data error resulting in for auto-tuning failure
2. Stop the inverter emergently during Auto-tuning

I checked the motor settings, and here's the question...

The motor is 3 phase, dual voltage, has both 240 and 400VAC on the plate.

I'm running the inverter off single phase so I set it 240VAC, 3.4A, 0.8kW, 1380rpm

Should I change that to 400VAC, 1.7A?

The manual assumes I know because it's obvious