Dyna mechtronics DM3000 lathe , mach conversion

[dazza]

[QUOTE=Jonathan;51530]
Look at what the spindle (which oddly enough I can't see in the photos?) is connected to - there's likely an encoder and some sort of driver for the motor. Also see what the toolchanger connected to.
QUOTE]
the spindle motors an SEM MT30 U4-48 MT30 Series Servomotors
theres a big board see image for the spindle motor, theres so many parts,and the manual really only covers operation and maintenance below spindle servo board p/n-ss-227-rev.3




the power supplys are both 24v and the one on the end 5v

various other bits,the board below looks to be some kind of breakout board, theres connector sockets marked L,T,X,Z, T being for the tool changer and the L? and a blue socket on the back the encoder ribbon plugged in to. p/n-3000-ds-213-rev.4a

drivers were in a sorry state and looked to have been repaired a number of times

tach