Threaded View
-
18-11-2013 #1
I'm currently testing the first (Y) axis on my Warco WM16 mill conversion. I'm using standard M542 drives with THESE 4.2A, 3nm stepper motors and have noticed significant vibration at very low speeds. Is this a problem caused by lack of cable screening or is it a setup issue? At certain speeds the whole machine and stand will vibrate. At higher speeds, there are no issues. I've tried running the motor unmounted but it still vibrates at very low speeds. The motor is bolted to a solid mounting. Should I use some sort of rubber mounting to reduce the vibration or is it something I will have to live with?
Last edited by birchy; 18-11-2013 at 02:26 AM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Stepper Motor Driver - cheap similar to ArcEuro 4.2A Bi-Polar Stepper Motor Driver
By craynerd in forum Motor Drivers & ControllersReplies: 1Last Post: 16-03-2014, 07:29 PM -
motor mount vibration vs torque'd bolts
By dsc in forum Gantry/Router Machines & BuildingReplies: 6Last Post: 22-10-2013, 10:36 AM -
M542 driver (Zapp) half or full current?
By Smiler in forum Stepper & Servo MotorsReplies: 9Last Post: 09-07-2013, 09:02 PM -
M542 Driver
By Swarfing in forum Motor Drivers & ControllersReplies: 28Last Post: 28-06-2012, 09:12 PM -
ZP5A-INT breakout an M542 driver problems
By ciaranconlon in forum Motor Drivers & ControllersReplies: 2Last Post: 09-04-2012, 05:52 PM
Bookmarks