Hybrid View
-
18-11-2013 #1
Last Activity: 13-05-2015
I'm using LinuxCNC set as per the picture below. Dip switches on drive are set to 800 steps (all switches 'off' except for 5, 7 and 8). I've also tried running at 1600 steps (and changed "Driver Microstepping" to 8) which did improve the resonance slightly. At 3200 steps, I had some error message related to the RTAI (realtime kernel). I didn't look up the specifics of the error as I just assumed it was related to the step rate being too high.
Last edited by birchy; 18-11-2013 at 07:20 PM.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Stepper Motor Driver - cheap similar to ArcEuro 4.2A Bi-Polar Stepper Motor Driver
By craynerd in forum Motor Drivers & ControllersReplies: 1Last Post: 16-03-2014, 07:29 PM -
motor mount vibration vs torque'd bolts
By dsc in forum Gantry/Router Machines & BuildingReplies: 6Last Post: 22-10-2013, 10:36 AM -
M542 driver (Zapp) half or full current?
By Smiler in forum Stepper & Servo MotorsReplies: 9Last Post: 09-07-2013, 09:02 PM -
M542 Driver
By Swarfing in forum Motor Drivers & ControllersReplies: 28Last Post: 28-06-2012, 09:12 PM -
ZP5A-INT breakout an M542 driver problems
By ciaranconlon in forum Motor Drivers & ControllersReplies: 2Last Post: 09-04-2012, 05:52 PM
Bookmarks