Help with Mach3 inputs and VB script ?

[EddyCurrent]

Good shed day today !
Right, the BOB does indeed stop the stepper drivers and VFD, plus with the timing problem gone my RESET button on the panel resets both the electronics and Mach which I think is great.
Also got my Elte spindle fired up today using a diycnc.co.uk spindle board. An on board relay selects RUN and the 0-10v output sends reference to the VFD. By entering say S12000 M3 the spindle fires up at half speed, then entering M5 it stops and the relay drops out the RUN signal. Had it up to full 24000 RPM just lying on bench, no vibration, fairly quite.
So a good day, RESET works great, spindle works great, not putting charge pump relay in E/stop circuit, Guinness in't fridge.