Thread: Hello from croatia
-
05-04-2009 #1
Hello to all,im from Croatia,employed as maintaining maschinist,bulding first CNC mill,hardware is almost done,I post some pics when i finish.(sorry for poor english)
-
12-04-2009 #2
-
12-04-2009 #3
Hi Smiler,I post some pics tommorow,its a small proper mill,my first design,whole from steel.Have no time to finish,to much work at job.
Thanks for interest.
-
13-04-2009 #4
-
13-04-2009 #5
Hello Jeff,you are right,but sometimes its better to think twice before proceeding.I already posted some pics, i dont know where they are!I am going to post them again.
Last edited by Lee Roberts; 14-04-2009 at 03:58 AM.
-
13-04-2009 #6
Now thats an impressive little beastie :D
what are you going to use as a spindle?
-
13-04-2009 #7Nothing is foolproof......to a sufficiently talented fool!
-
13-04-2009 #8
Thanks for all your positive feedbacks.In the matter of the spindle,I'm not going to use anything large in first setup,one dc motor 200w3350rpm and a spindle I made myself.Spindle housing of steel with small head(one collet diameter;have few pieces of these,3,4,5,6,8 holes),I have some angular bearings(7201C),and I think it will be good for the first run.Later,I have in mind spindle with morse 3,ER20 collet chuck,which I also plan to do myself,and servo motor with VFD.
-
13-04-2009 #9
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: Hello from Croatia
By kuki in forum New Member IntroductionsReplies: 1Last Post: 04-01-2011, 06:07 PM -
NEW MEMBER: New member from Croatia
By damjan in forum New Member IntroductionsReplies: 2Last Post: 28-11-2010, 08:10 PM -
NEW MEMBER: Greets from Croatia
By zuluf in forum New Member IntroductionsReplies: 1Last Post: 31-10-2010, 06:40 PM
Bookmarks