Hybrid View
-
21-01-2014 #1
Last Activity: 29-06-2025
In addition any cables going to a motor, stepper or spindle, should be physically separated from the other signal cables as much as possible and it's not too bad if they cross at right angles, running them parallel is the worst. Of course this is difficult to do especially in the energy chain.
-
21-01-2014 #2
Last Activity: 19-01-2024
If you want to try a potential quick fix for false trips then try playing with de-bounce in Mach3 Config.
No substitute for correct wiring but it may get you going untill your ready to re-wire.?
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Chinese 6040 CNC Router Advise Needed
By Bob Hepple in forum Chinese MachinesReplies: 24Last Post: 27-11-2013, 12:00 PM -
Has my air compressor died?
By Jonathan in forum General DiscussionReplies: 9Last Post: 15-10-2012, 12:08 AM -
I need advise again
By habibuzziwa in forum General DiscussionReplies: 14Last Post: 08-10-2012, 10:08 AM -
I need advise
By habibuzziwa in forum General DiscussionReplies: 7Last Post: 03-10-2012, 10:50 AM -
Advise on buying a new CNC router.
By brlaw in forum General DiscussionReplies: 2Last Post: 09-07-2011, 05:00 AM
Bookmarks