Threaded View
-
01-01-2014 #8
Last Activity: 02-10-2024
Happy New Year !
See the circuit board mounted on the end of the motor, make sure it goes back in exatly the same position. You can see it has slots to allow rotation.
If you are using a 500v Megger type insulation tester keep it well away from the same circuit board, only test at the windings (U, V, W), if it's just a multimeter that will not be a problem.
On the main board there is a white connector with 2 white wires going to it, beside it is a 3 leg component mounted on a small vertical heatsink, well the legs on that do not look good, it looks in fact like someone has changed it before. Maybe this is a component that blows often ?
There is a rectifier with GBU 12G written on it, this could also be causing the problem.
http://www.datasheets.pl/bridge_rectifiers/GBU12A.pdf
Last edited by EddyCurrent; 01-01-2014 at 08:16 AM.
-
The Following User Says Thank You to EddyCurrent For This Useful Post:
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Can anyone identify this control board and help use it
By SimonMaltby in forum Chinese MachinesReplies: 4Last Post: 28-12-2017, 01:35 PM -
eBay: Emco vmc 100 milling machine and control unit plus manuals
By Lee Roberts in forum Items On eBay UKReplies: 0Last Post: 15-06-2017, 05:16 PM -
FOR SALE: £500 Vertical milling machine on stand, ready for steppers and control system
By petemono in forum Items For SaleReplies: 0Last Post: 06-02-2014, 09:52 PM -
eBay: Denford Novamill SmartStep Control Board + Spindle Board
By danielbriggs in forum Items On eBay UKReplies: 0Last Post: 30-05-2013, 06:52 AM -
Help! Stepper control board
By Ross77 in forum General ElectronicsReplies: 10Last Post: 28-05-2009, 01:42 AM
Bookmarks