angular contact bearings - back to back, further apart

[dsc]

Indeed I've screwed up the lines showing the centers, so the above shows a face-to-face rather than back-to-back (I think). Re done here:



Original I had tapper rollers in the design, the issue with those was no seals. ACs offer seals as well, but the idea stays the same.

Thanks m_c.

Regards,
dsc.

[JAZZCNC]

M_C beat me to it about wrong way around but I would also had that you'll want the locknut approach with locking grub screw rather than the just tightening a thread to a torque value.