Chinese 3040T Arrives

[Gregor]

Hi
I am going to change the cables going to the motors as I have been reading that the cables fitted are not very good,could anybody give me some advice on what cable to use and were to buy them,
thanks

[Clive S]

Hi
I am going to change the cables going to the motors as I have been reading that the cables fitted are not very good,could anybody give me some advice on what cable to use and were to buy them,
thanks

If it ain't broke don't fix it. Have some fun with the machine first. If you really want to change them I would use either 0.75 or 1mm^2 CY 4 core cable for this machine. here is one place Cy Cable Per Meter 4 core (0.75mm CY Cable) ONLY £0.48.. ..Clive

[JAZZCNC]

If it ain't broke don't fix it. Have some fun with the machine first. If you really want to change them I would use either 0.75 or 1mm^2 CY 4 core cable for this machine. here is one place Cy Cable Per Meter 4 core (0.75mm CY Cable) ONLY £0.48.. ..Clive

Good advise because it's not just the cable being rubbish thats the problem there's the connectors has well plus often the Cable chain is too small so you'll end up replacing has well. Only do it if needed and then do the Lot.

[Pointy]

If it ain't broke don't fix it. Have some fun with the machine first. If you really want to change them I would use either 0.75 or 1mm^2 CY 4 core cable for this machine. here is one place Cy Cable Per Meter 4 core (0.75mm CY Cable) ONLY £0.48.. ..Clive

Has anyone used this cable/supplier? It seems extremely cheap, but is it any good?

Regards,

Les

[Clive S]

Has anyone used this cable/supplier? It seems extremely cheap, but is it any good?

Regards,

Les

I have used them several times with no problems ..Clive

[JAZZCNC]

Has anyone used this cable/supplier? It seems extremely cheap, but is it any good?

Regards,

Les

Yes I've used them and the wire was ok but a little brittle compared to the stuff I get from CSE cables, thou it is cheaper.
Flexible Control Cable