Chinese 3040T Arrives

[JAZZCNC]

I used an end mill with 2 flutes should I have used an end mill with 3 or 4 flutes ?

No 2 flutes is fine and with more flutes the faster you would need the feedrate etc. From the Video it's hard to judge the feedrate because it's speeded up but from what I can see your cutting far to shallow and probably to slow.?

What were the feedrate and depth of cut.?

[Gregor]

the cut feed rate i set on cambam was 600 the depth was 0.5 and depth plunge rate was 200, the spindle speed was max which is only 8000 on this machine.