Rockcliff Router Build, MDF

[Lee Roberts]

So i started looking at how i was going to mount my motors and this is what i did:





So i used some Stainless Steel Tube, and some M5 Threaded rod, now i just needed some ali plates.



So i did some testing as i'v never worked with ali befor:







Ok i can see what its going to be like so lets crack on and see what we can come up with:



above i used some Center Drills to try and get my holes as good as i could, its taken a few gos at getting these right but after i printed some markings to work for on stick backed papper it was that bit easyer!

I managed to get all 4 holes done and also counter sunk them ready to recive the ss tubes above: