I'v hooked this up to a driver and tested how it runs/jog's and everything is nice and smooth, now i need some delrin drive nuts for my other 2 axis's:



So now i'v got my gantory table built and the delrin drive nuts mounted:



again the image i a bit "iffy" everything is allot more square and strate then the pic is showing:

So i'm going to need one of my drive nuts off center because of the fixing screw placments, i'v also now got an issue with the leadscrew hitting the heads for the delrin nut:





On the other side my delrin nut is also sitting to low because of the channel i routed out in error:





Ok that sides not a problem, i quick do-dar with a hand file across the what-u-ma-call-it soon sorted that problem out: