Threaded View
-
16-01-2014 #4
Last Activity: 17-03-2017
A low-end Pentium 4 or Pentium 5 with XP is more than adequate for most small CNC machines. I used to use an IBM ThinkCentre 50 (P4) circa 2002-ish with 1Gb RAM and 40Gb disc.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
hardware to suit Mach 3
By PAULRO in forum Artsoft Mach (3 & 4)Replies: 0Last Post: 13-03-2014, 10:04 PM -
NEW MEMBER: Newbie - question on bit types
By Steven W in forum New Member IntroductionsReplies: 2Last Post: 16-05-2013, 12:06 PM -
FK12 BEARING, tighten on lead screw first - newbie question?.
By Mark Snape in forum Lead Screws, Nuts & SupportsReplies: 4Last Post: 08-03-2012, 10:59 AM -
newbie with a tool id question
By bigmatt-s2rst in forum Tool & Tooling TechnologyReplies: 2Last Post: 03-10-2011, 06:16 AM -
Newbie Question ...
By Wobblybootie in forum General DiscussionReplies: 1Last Post: 03-12-2009, 05:32 PM
Bookmarks