Hiya, old thread, but are you still looking for this info?

can i ask, how did you wire up your spindle controller? im currently wiring mine up after putting it off for 2 years! I need to know what voltage the signals need to be that switch the yaskawa connector block thing, been working out al;l of the pin outs but cannot confirm if it is a 24ish voltage (think its 18 or 28 i believe is wha it supplies of my head...


how did you control your spindle speed?

Thanks

Nat

Quote Originally Posted by Roadrunna View Post
Anybody else have any info on these drive boards ?

Could still do with some details of the burnt components or if anyone has one/knows where I can get hold of one.
Cost for repairing this one shouldn't be much at all however i'll still need one for the other machine as well.

Thanks in advance.

Si