Have you checked for power going to the stepper drivers?

You may need to check the pinout wiring to determine what signal lines are going to which pin of the breakout board and remap these ports and pins in Mach3.
It sounds like your pins are not mapped which is why your machine is not moving.
I have a marchant dice machine, now put into storage as i upgraded to a 6040.

QUOTE=Raul;123720]Hi Gav,

Sorry to hear that this CNC are so bad, but do you have by any chance the set up of Mach 3? because I have and A1 size CNC but everything seems ok, green light on, mach3 moving, but the step motor not, and I am going crazy about it. Can you help me?

Best regards[/QUOTE]