Quote Originally Posted by Davek0974 View Post
There is no problem JAZZCNC, I'm just looking for facts and figures at the moment.

I now have it set for 15,000mm/min and 1300 mm/sec/sec and it's been running a pen over various files repeatedly and has not missed a step yet.

Seems pretty good so far, I think that speed is more than enough for a small machine???
To be honest I forgot this was for a plasma machine so very little forces involved and at those speeds your running about half the motors speed which is about right where I'd have predicted would be ok without missing steps etc. You may find you'll need to tune slower if ever cutting forces are involved.?