. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 01-02-2014 #2
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    Post the code because chances are it uses G31 and the Probe input.? It could also need a Macro.?

    Edit: To be honest this could easily be done just by modifieing the M3 (Spindle on) macro to use G31 command and the probe input. It would then set all the Dro's etc and pierce height etc from within the Macro. All you would do is insert M3/M5 in the G-code which you may be doing anyway for torch on/off.?
    Last edited by JAZZCNC; 01-02-2014 at 02:38 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. NEW MEMBER: In over my head
    By Tele45 in forum New Member Introductions
    Replies: 8
    Last Post: 03-01-2014, 02:30 PM
  2. advice on floating bearing - outer ting rotating
    By dsc in forum Lead Screws, Nuts & Supports
    Replies: 8
    Last Post: 18-11-2013, 02:23 PM
  3. ballnut housing and floating end ballscrew assembly
    By dsc in forum Lead Screws, Nuts & Supports
    Replies: 12
    Last Post: 12-07-2013, 08:22 AM
  4. non-locating / floating bearing - shaft location
    By dsc in forum Linear & Rotary Motion
    Replies: 5
    Last Post: 28-06-2013, 10:07 PM
  5. Driving floating end (ballscrew)
    By blackburn mark in forum Lead Screws, Nuts & Supports
    Replies: 16
    Last Post: 11-09-2010, 11:55 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules