. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #24
    Mark I completely 100% agree there's nothing wrong with it in my eyes either.! . . .BUT and the whole point in MY original post, forget all the stuff after, was to becareful what you post publicly. Which in this case was Esp true because the little arrogant shit was putting down a bloke who just gave what was asked for a "Quote" in the full knowledge he could safely do so without fear of the Taxman. Jon then gave out Specific Figures of what He " illegaly in Tax mans world" charges which is in my eyes dumber than dumb considering you have just tried to belittle a hard working bloke who could possibly be very pissed off .!!

    My frustration came from the narrow mindedness of my post being twisted into something it wasn't, which seems to be happening a lot lately from the ones who clearly don't like me, which is fair enough as it's just par the course with forums.! . . . But I won't stand by and say nothing esp when I've only tried to pass on sound advise for someones own good.! . . . . . But on reflection and following his comments aimed to me I hope some Bastard does report him has he needs that arrogant chip knocking off his shoulders, thou rest assured it won't be me.!
    Last edited by JAZZCNC; 01-02-2014 at 12:40 PM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Best type of shed.
    By Philly in forum General Discussion
    Replies: 14
    Last Post: 03-11-2018, 08:17 PM
  2. Commercial CNC machine lifespan?
    By sarahloyd in forum Machine Discussion
    Replies: 13
    Last Post: 24-01-2014, 02:21 PM
  3. Commercial Machine choices...
    By jashington in forum Marketplace Discussion
    Replies: 4
    Last Post: 10-10-2013, 10:38 AM
  4. NEW MEMBER: from a shed in Nottinghamshire
    By Andrew Wilding in forum New Member Introductions
    Replies: 3
    Last Post: 17-09-2010, 12:34 AM
  5. Commercial Sieg X1 anti backlash nuts ?
    By cweeks in forum Milling Machines, Builds & Conversions
    Replies: 0
    Last Post: 28-05-2009, 06:41 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •