-
02-02-2014 #1
Afternoon,
I have the following items I have collected with a view to building a CNC project which I would like to dispose of.
2No Berger Lahr VRDM3910/50LVBOO - tested working
2No Berger Lahr WD3-004.0801 - tested working
2No Berger Lahr SER397/4L3SS0TO - untested
2No Mitsubishi MR-J2S-40A - untested
2No HC-MFS43 - untested
Plus a bunch of related cabling. I would like £500 firm for all of this, as a job lot. I am in N Kent but could deliver it to N Kent, S Essex or East/central London within reason, or you could collect.
Thanks for looking,
Pete.
-
02-02-2014 #2
If you guarantee me they all work then I'm interested at the money you want but not if any are untested.
-
02-02-2014 #3
Hi Jazzcnc.
All of this stuff has been pulled from working machines and well-handled, though it wasn't me that pulled them.
The top two pairs I have powered and controlled with mach3, through a range of steps up to the max of 10k steps/rev.
The middle motors I have no way (or knowledge of how) to test, no canbus controller.
The bottom two pairs are matched together drive/servo units so I could power them for testing but I might need my hand held as to how.
Pete.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
switching from steppers to servos - STEP / DIR control
By dsc in forum Stepper & Servo MotorsReplies: 6Last Post: 18-06-2014, 12:41 PM -
Drives without steppers
By Wobblycogs in forum Gantry/Router Machines & BuildingReplies: 5Last Post: 27-03-2014, 01:07 PM -
FOR SALE: Steppers (3), Drives (3), Breakout board and 500w 48v PSU
By deannos in forum Items For SaleReplies: 13Last Post: 11-10-2012, 10:44 AM -
FOR SALE: Steppers (3), Drives (3), Breakout board and 500w 48v PSU
By carl0s in forum Items For SaleReplies: 6Last Post: 30-05-2011, 01:03 AM -
Mariss Freimanis Steppers vs Servos Advantages/Disadvantages of both
By Lee Roberts in forum Stepper & Servo MotorsReplies: 0Last Post: 02-10-2007, 09:08 AM
Bookmarks