Sheet support for a plasma machine?

[Robin Hewitt]

Interesting question the positioning of slats...

If you have a small piece of metal to cut then you need the slats closer together.

If you have a large piece to cut then the slats can be further apart.

However, you might decide that all small pieces are to be placed at one end/corner of the table and that is the only part requiring close slats.

If you go for big spacing and big sheets remember to cut all inlines before cutting outlines. It might move.

If you think you will do lots of small stuff with rare forays into big stuff, you might even consider a small water table at one end of a large table.

The possibilities are endless but rarely explored.