Giant 20' x 3' x 2' router build

[JAZZCNC]

i was wondering about using 60x60 or 80x80 for the z axis but the 40x80 in a relatively short length seams crazy strong as it is.

Yes it may seem strong Now but promise you when there's a spindle on the end with cutting forces acting on it then at full extension at this length which you would be while cutting ply it will twang like a guitar string.!!
The Z axis is THE single most important area on a CNC machine and seen as your going to so much trouble and expense using Profiled linear rails etc why spoil the broth for a pinch of salt.?

Regards R&P then yes it would work ok and seen as your using it on other axis makes sense but you would still need drive it from both sides, thou it would be easy enough to run a shaft across the back of profile. As would it to connect ballscrews with a timing belt, which woud be my first choice.

Tip for you if you use the Bosch Rexroth 45 x90 or it's equivlent then the BK/BF12 bearing block hole centres match the slots and make fastening very easy.
This stuff Profile 45x90S slot 10