Giant 20' x 3' x 2' router build

[JAZZCNC]

To be honest I reckon if you use one of the wide Rads with twin 120mm fans then you'd get away with it no problems. Only reason I'm trying single 120mm Rad with fan is so can incorporate into Z axis cover and keep it all together but light at same time. Test's so far seem to show it will work and wit wide Rad so twice the cooling then I'm 99.9% sure it will work.

Edit: I even tried it with convection using no pump and while it worked felt it just not quite good enough.!

[charlieuk]

Been playing about with a few bits like mounting the screen to the wall , putting the vfd screen on the out side of the box and also found a good use for round rail supports to make nice solid simple mounts for the proximity switches over my slightly crude aloy boxes.

[charlieuk]

I'm having a few problems with my home and limit switches, I had a similar problem the last week but managed to sort it by adjusting it through the input signal filters in the csmio plug in however now I can't find the happy medium I found last time the video should explain the rest.

[JAZZCNC]

Charlie are you using shielded wire for the cable back to control box and is the sheild earthed just one end inside the control box.?
Also is the machine frame earthed to same earth point.?

You have long wire runs so they will act like antenna picking up any noise so you'll need to Eliminate this really before you'll get any joy.
I would also try a differant switch you maybe have poor switch with slow components giving slow reaction times.?

[EddyCurrent]

What do you have debounce set to in Mach3 General Config ?

[charlieuk]

What do you have debounce set to in Mach3 General Config ?

Zero would this be the same as the filter in the csmio plug in or have the same effect ?

[charlieuk]

What do you have debounce set to in Mach3 General Config ?

I had a read up and I think it's a similar thing however it didn't seam to make any difference at all that I could figure I tried up to 4000.

[JAZZCNC]

What do you have debounce set to in Mach3 General Config ?

Mach De-bounce isn't used with Csmio. More advanced Noise Filtering is done in the controller thru the Plug-in.

[charlieuk]

Yes it's all shielded at one end the Ali frame is directly bolted to the floor the moving part of the gantry though may not have any sort of ground unless it can travel through the Hiwincarriages. The problem seams to effect all switches. I was wondering about replacing a switch but wire it straight to the csmio ? Would it be best to disconnect the rest of them if I did that?

[JAZZCNC]

Ali frame is directly bolted to the floor the moving part of the gantry though may not have any sort of ground unless it can travel through the Hiwincarriages.

Not to be trusted so run a Earth wire from both the frame and the Gantry back to the Star point in the Controller.