Threaded View
-
15-02-2014 #2
It depends on various factors.
.
Drilling is the quickest way to remove metal, however you need to make sure you're spindle is capable of the required torque.
With limited torque, you may find spiral milling will work better with your spindle.
.
Best bet is try some figures at FSWizard - Free Advanced CNC Speed and Feed Calculator and see what will work with your spindle/available tools.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
general discussion/social meeting
By luke11cnc in forum General DiscussionReplies: 20Last Post: 13-06-2016, 02:26 PM -
A couple of general design questions - ball-screw thread length, stub-shaft etc.
By Wal in forum Gantry/Router Machines & BuildingReplies: 4Last Post: 02-01-2015, 08:32 AM -
VFD in main electronics cabinet/general layout?
By m_c in forum Spindles & Drive MotorsReplies: 4Last Post: 11-04-2013, 06:00 PM -
drilling brass?
By irving2008 in forum Metalwork DiscussionReplies: 23Last Post: 04-08-2012, 03:56 PM -
CNC Novice, Looking to build, little help? Design, Sourcing and General Help
By kylelnsn in forum Gantry/Router Machines & BuildingReplies: 1Last Post: 29-02-2012, 01:32 PM
Bookmarks