Thread: Epoxy pouring advice
Threaded View
-
18-02-2014 #11
That sounds like a challenge :-). The belt sander was a late addition to my tool selection so perhaps I'm still in the "how did I work without this" phase. I'd have the sander over at 45 deg to the poured surface so that only the meniscus was touched. Pretty sure you could easily control it enough then to avoid damaging where the rails will be fitted.
Thread Information
Users Browsing this Thread
There are currently 20 users browsing this thread. (0 members and 20 guests)
Similar Threads
-
Self levelling epoxy resin
By flanagaj in forum Gantry/Router Machines & BuildingReplies: 5Last Post: 21-11-2020, 01:47 AM -
Epoxy granite or mineral casting
By mike mcdermid in forum Gantry/Router Machines & BuildingReplies: 46Last Post: 20-02-2014, 06:21 PM -
Epoxy Granite Molds?
By gavztheouch in forum Moulding MachinesReplies: 8Last Post: 18-02-2014, 07:28 PM -
Epoxy cast plastic injection tools
By gavztheouch in forum Moulding MachinesReplies: 0Last Post: 27-01-2014, 11:33 PM -
BUILD LOG: Vertical fixed gantry. Design & build. (Steel/epoxy)
By Greeny in forum DIY Router Build LogsReplies: 8Last Post: 19-08-2013, 08:26 PM
Bookmarks