CNC 3020 Enclosure/Upgrade

[JAZZCNC]

I am not sure if the front panel is on it's way back to me yet, but if it doesn't arrive, tonight I will pre-wire the joysticks and buttons ready for it.

Yes on it's way sent yesterday morning recorded delivery so should be with you hopefully.!

[Pointy]

Yes on it's way sent yesterday morning recorded delivery so should be with you hopefully.!

It's here and after a small amount of filing and reaming.........

The more astute of you may have noticed the panel is the other way up, that is because there were a few scratches on the other side. I actually prefer it this way up anyway!

I just have to connect everything up inside now!

Thanks again Jazz, great job!

[GEOFFREY]

A very nice "swanky" looking panel. G.

[JAZZCNC]

The more astute of you may have noticed the panel is the other way up, that is because there were a few scratches on the other side. I actually prefer it this way up anyway!

Yes I Did my best to protect it from scratches by flooding it with coolant but because it's soft shity aluminium it comes off the cutter like curly chewing gum.!
I didn't have any tape other wise I'd have taped it up. There was no point using side with plastic on either because that stuff just goes mushy with coolant and gets ripped off then wraps around cutter which with small cutters easily breaks them.!

Looks Good thou..