Threaded View
-
19-02-2014 #1
I just measured the TiR on my Kress 1050, and it is around 0,04mm.
This seems a bit high, is there anything you could do to improve it? I would guess this TIR is one of the reasons I have problems getting clean cuts in brass. (CZ120)
I am considering upgrading to a better spindle, does anyone have suggestions for moving up a notch?
The eBay watercooled "Chinese spindles" seems to be quite a gamble, I would prefer a spindle with a warranty that counts for something.
Regards,
Hauk
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Cut depths and spindal speeds to improve finsh time
By Fivetide in forum Tool & Tooling TechnologyReplies: 23Last Post: 21-05-2015, 08:39 AM -
trying to improve my board game
By cubikoman in forum General DiscussionReplies: 28Last Post: 12-05-2012, 06:57 AM -
Upgrade
By Dopy in forum General DiscussionReplies: 0Last Post: 09-11-2011, 01:57 AM -
BUILD LOG: Time for mk2 upgrade!
By routercnc in forum DIY Router Build LogsReplies: 16Last Post: 26-02-2011, 11:38 PM -
NEW MEMBER: cubikoman needs to improve quality of his boardgame
By cubikoman in forum New Member IntroductionsReplies: 2Last Post: 16-02-2011, 12:17 PM
Bookmarks