laser cutter/engraver rebuild build log

[mekanik]

IF you have a lathe, next time make a sleeve with a hole a nice fit on your desired tap, and a nice fit in one of your bigger holes in the jig.
As a rule i usually centre /drill & tap all @ the same setting, ie without moving the setup but you could use your dial or digital readout to do the same, after your holes are drilled put a centre in your spindle to locate in the end of your tap and everything should be square, if you have a digital readout, much more better.
Regards
Mike

[gavztheouch]

Good ideas thanks for the tips mike.

[gavztheouch]

[Palmar]

Any news for this project?

[kingcreaky]

typed a response, then realised how old the post was... please delete this comment..