Quote Originally Posted by Isaac View Post
I could probably push it a little more but I was getting sprayed with hot aluminium chips. It actually sounded better with the deeper doc.
Then your cutting something like correct because you want the heat to leave with the chips and not stay in the material or cutter. That said 22K and only 800mm/min is a little fast and slow. You could try lowering the Spindle speed a little to around 15K or up the feed rate.

1050 is a pain in the Arse and I don't cut enough so still haven't found the balance but I've had most success with twin flute slot cutters and cut full depth in 2.5mm sheet.