Thread: Job undersized
Threaded View
-
09-03-2014 #1
Hi, folks.
I'm using a Zen 7x7, Mach 3 & VcarvePro. The finished job is undersized.
I've-
1) Calibrated the router carefully, it's as good as my vernier can measure.
2) Entered the actual tool cutting diameter/width in Vcarve, and ensured it's in Mach3, too (3.175mm endmill)
3) Looked at the produced G-code, & it's OK.
4) Ensured the tool positions are the same, in Vcarve & Mach3
I have tried a work-around by fudging the tool dia, but that's not my preferred solution, I was wondering if there was anything I was missing? Apart from a life...
Any ideas welcomed...
TIA
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks