Boxford vmc260 to mach3 conversion

[LucD]

I have recently acquired one of these drives. Does anyone know what power output they have? I could also do with inputs and outputs.

Thanks

Luc

[Roboteernat]

I have recently acquired one of these drives. Does anyone know what power output they have? I could also do with inputs and outputs.

Thanks

Luc

Hiya, What drive do you have? If it is stock from boxford, then you will want to look at getting a new breakout board and wiring that in with some new stepper drivers.

If that i sthe case, these are the stepper drivers i use: https://www.ebay.co.uk/itm/DM860I-Di...YAAOSw1QpZ5ZIL

after upgrading from MA860H as i was able to https://www.ebay.co.uk/itm/Durable-M...wAAOSwVVlcxsbL

Both work fine.

The breakout board, i used https://www.ebay.co.uk/itm/1pc-5-Axi...IAAOSwgvVdOIPz This worked well but i had to change to:

I then changed to this one to have a charge pump on the board to stop any problems with our H&S board. https://www.ebay.co.uk/itm/Engraving...-/162783086981

If you have something else, please advise.

Im running Mach3 with these and have just installed an Ethernet smoothstepper.