Boxford vmc260 to mach3 conversion

[Roboteernat]

Im in the process of converting (well towards the latter part now) of converting my 260 VMC machine. i went down the new BOB and stepper driver route and am using the original spindle controller.
Its working well, except i have just dismantled mine to replace balls in the Y axis as its a bit slack.

I have the version with the auto tool changer (now not used) and air mist coolant and auto lube pump.
Pics are available here: https://flic.kr/p/rf37eX

If you have any issues with wiring or need to trace it, and it is the same as mine in the images on my flickr album, ask me as i have been tracing the wiring and can help wire it up.
If it is the same, i may however ask if you could trace a wire for me! :) The door interlock and how it wires up the the spindle controller/emerg stop? and also the output from the 3 large resistors.

Thanks

Nat