Threaded View
-
31-12-2019 #26
Last Activity: 15-07-2024
Doddy,
This application is fairly high impedance so I think it might work without problems. If not then the tool will just keep going until it barges it's way through the oxide to a nice fresh layer of aluminium anyway
KitAn optimist says the glass is half full, a pessimist says the glass is half empty, an engineer says you're using the wrong sized glass.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
1/4" / 6mm edge finder?
By jcb121 in forum Marketplace DiscussionReplies: 0Last Post: 18-03-2013, 02:58 PM -
Need some money making project ideas
By Fivetide in forum Marketplace DiscussionReplies: 10Last Post: 23-11-2012, 09:50 AM -
Making Aluminum offcuts - what tool?
By lateAtNight in forum Tool & Tooling TechnologyReplies: 15Last Post: 28-07-2012, 02:44 PM -
Electronic edge finder: how do they work?
By irving2008 in forum Probing, Digitizing & ScaningReplies: 14Last Post: 29-08-2009, 10:25 PM
Bookmarks