Thread: Emco C5 spindle motor control
Threaded View
-
18-03-2014 #1
Gentlemen
Am returning to the Forum after a long break as I'm upgrading an Emco C5 to "more modern electronics".
I contacted a local supplier seeking a kit of parts which were duly supplied and consists of Bob, stepper motors, drivers, software, etc.
Regarding the spindle motor (180v dc) I have ordered an Asian PWM controller and a Homann isolating interface. My problem is there appears to be no facility on the HG08 Bob to connect this controller or the spindle position index sensor, just a relay.
As screw cutting is high on my list of requirements can anybody suggest a more appropriate Bob or a way of using the HG08 or any other sensible ways of deriving speed and position control with Mach3.
My Thanks in anticipation.
GeoffVLast edited by GeoffV; 18-03-2014 at 08:30 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
AC servo motor to replace a 3 phase induction motor on a mill spindle.
By rnr107 in forum Spindles & Drive MotorsReplies: 2Last Post: 23-04-2014, 03:14 PM -
EMCO Spindle Control
By Pete92 in forum Spindles & Drive MotorsReplies: 1Last Post: 06-11-2013, 10:20 PM -
Help with spindle control
By wizzy in forum Spindles & Drive MotorsReplies: 4Last Post: 12-02-2011, 12:51 AM -
motor control
By Phil Gravett in forum Motor Drivers & ControllersReplies: 6Last Post: 09-06-2009, 05:02 PM -
Motor control
By crazy horse in forum Gantry/Router Machines & BuildingReplies: 3Last Post: 13-03-2009, 09:31 PM
Bookmarks