Thread: Mach3 G76 head scratcher
Threaded View
-
25-03-2014 #1
Gentlemen
I purchased a licenced copy of Mach3 lathe to drive an Emco c5 which is being upgraded.
Mach3 was downloaded and successfully installed on my office laptop running windows 7 and works correctly including G76 threading canned cycle.
Next I installed Mach3 from the same source onto a Dell OptiPlex 745 PC which is mounted on the Emco C5 and copied the licence file into the mach3 folder. Once installed all appeared correct including the licence's name at the top of the program window, I say all appears correct except that it will not emulate a G76 threading cycle no matter what I do. I have tried reinstalling, copying the XML file from the laptop, hitting it! yet it refuses to read a G76 despite the first part of a test program running normally as far as the G76 line.
Has any one else found this problem or more to the point, a cure?
GeoffVLast edited by GeoffV; 25-03-2014 at 02:12 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: In over my head
By Tele45 in forum New Member IntroductionsReplies: 8Last Post: 03-01-2014, 02:30 PM -
WANTED: Milling machine head
By Ainis in forum Items WantedReplies: 0Last Post: 23-07-2013, 09:30 PM -
WANTED: Head Tram Square
By dudz in forum Items WantedReplies: 5Last Post: 31-03-2013, 01:03 PM -
diy Engraving head
By riche543 in forum Metalwork Project ShowcaseReplies: 2Last Post: 25-06-2012, 01:31 PM -
Sieg X2 head weight
By pequod in forum Sieg Milling MachinesReplies: 6Last Post: 25-08-2011, 11:09 PM
Bookmarks